Range Rover (LM) V8-4.4L (2009)
Sunroof / Moonroof Motor: Service and Repair
Roof Opening Panel Motor
Service Repair No - 76.84.07
Removal
1. Remove the overhead console.
2. Remove the roof opening panel motor.
^
Disconnect the roof opening panel motor electrical connector.
^
Remove the 3 screws.
Installation
1. Install the roof opening panel motor.
^
Tighten the bolts to 5 Nm (4 ft. lbs.).
^
Tighten the bolt to 10 Nm (7 ft. lbs.).
^
Connect the roof opening panel motor electrical connector.
2. Install the overhead console.
3. If the roof opening panel motor is to be replaced, the one touch and anti-trap function will become inoperative. Close the roof opening panel and
continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panel
calibration routine and reset these functions.