Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2384001.png)
Power Seat Switch: Service and Repair
Lumbar Control Switch
Lumbar Control Switch
Removal
NOTE: Front seat shown removed for clarity.
1. Position the front seat fully forwards.
2. Remove the safety belt lower anchor bolt cover.
1. Carefully release the clip from behind the front seat base side trim panel.
2. Remove the cover.
3. Carefully release the front seat base side trim panel.
^
Remove the 2 screws.
^
Release the 6 clips.
4. NOTE: Safety belt shown removed for clarity.
Disconnect the lumbar control switch electrical connector.
5. Remove the lumbar control switch.
1. Release the 2 clips.
2. Remove the switch.
