Range Rover (LM) V8-4.4L (2009)
Installation
NOTE: Make sure ABS module locating grommet is correctly seated in the bracket before installing the ABS module.
NOTE: Make sure the ABS module locating pin is correctly located in the grommet and the 2 isolators are fully seated in the brackets
1. Install the ABS module.
^
Tighten the nuts to 8 Nm (6 ft. lbs.)
^
Tighten the M10 and M12 unions to 15 Nm (11 ft. lbs.)
^
Tighten the M14 union to 17 Nm (13 ft. lbs.)
2. Connect the electrical connector.
^
Secure the latch
3. Connect the battery negative cable.
4. Bleed the brake system.