Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1428002.png)
7. Install the bleed tube to the brake caliper bleed screw and immerse the free end of the bleed tube in a bleed jar containing a small quantity of
approved brake fluid.
CAUTION: The brake fluid reservoir must remain full with new, clean brake fluid at all times during bleeding.
8. With assistance, depress the brake pedal steadily through its full stroke and allow it to return to the rest position. Repeat the procedure until brake
fluid, clean and air-free flows into the bleed jar.
9. When brake fluid, clean and air-free flows into the bleed jar, depress and hold the brake pedal down.
CAUTION: Make sure the bleed screw cap is installed after bleeding. This will prevent corrosion to the bleed screw.
10. With the brake pedal fully depressed, tighten the bleed screw to 10 Nm (7 ft. lbs).
11. Fill the brake fluid reservoir to the MAX mark.
12. Repeat the brake bleeding procedure for the remaining rear brake caliper.
^
Tighten the bleed screw to 10 Nm (7 ft. lbs).
WARNING: High performance front brake calipers have two bleed points. The inner bleed point must be bled before the outer bleed point.
Braking efficiency may be seriously impaired if an incorrect bleed sequence is used.
CAUTION: Make sure the bleed screw cap is installed after bleeding. This will prevent corrosion to the bleed screw.
13. Repeat the brake bleeding procedure for each front brake caliper, following the above sequence.
^
If access is restricted to the front caliper outer bleed screws, rotate the road wheels to gain access.
^
Tighten the bleed screws to 19 Nm (14 ft. lbs).
