Range Rover (LM) V8-4.4L (2009)
6. Remove the brake pedal and bracket.
^
Disconnect the stoplamp switch electrical connector.
^
Remove and discard the 3 nuts.
^
Reposition the brake booster and brake master cylinder.
NOTE: Do not disassemble further if the component is removed for access only.
7. Remove the stoplamp switch.
^
Release the clip.
8. Remove the stoplamp switch bracket.
^
Remove the 2 nuts and 2 bolts.
^
Remove the brake pedal return spring.
Installation
1. Install the stoplamp switch bracket.
^
Install the brake pedal return spring.
^
Tighten the nuts and bolts to 10 Nm (7 ft. lbs.).
2. Install the stoplamp switch.
^
With the brake pedal released, make sure the stoplamp switch is in contact with the brake pedal.
WARNING: Make sure that new nuts are installed.
CAUTION: The nuts must be re-torqued after 20 minutes.
3. Install the brake pedal and bracket.
^
Reposition the brake booster and brake master cylinder.
^
Tighten the nuts to 26 Nm (19 ft. lbs.).
4. Secure the brake booster push rod to the brake pedal.
^
Install the pin.
^
Install the clip.
5. Install the driver side footwell duct.
^
Tighten the screws.
6. Install the driver side closing trim panel.
^
Connect the footwell lamp electrical connector.
^
Secure the vehicle diagnostic socket.
^
Tighten the screws.
7. Install the floor console extension.
^
Secure the clips.
^
Tighten the screw.
8. Connect the battery ground cable.