Range Rover (LM) V8-4.4L (2009)
1. Clean the components.
2. Inspect the caliper piston seals for damage.
3. Install the brake caliper.
^
Tighten the new bolts to 65 Nm (48 ft. lbs), then a further 90 degrees.
4. Connect the brake hose to the brake caliper.
^
Clean the component mating faces.
^
Install new sealing washers.
^
Tighten the brake hose union to 32 Nm (24 ft. lbs).
5. Position a bleed jar containing a small quantity of approved brake fluid. Connect the bleed tube to the bleed screw and loosen the screw.
6. Press the pistons into the caliper housing.
^
Tighten the bleed screw to 19 Nm (14 ft. lbs).
7. Repeat the above process for the other 2 pistons.
8. Disconnect the bleed tube and remove the jar.
9. Install the brake pads.
^
Install the anti-rattle spring.
^
Install the pins, making sure the pin collets are fully engaged in the caliper.
10. LH side only: Connect the brake pad wear indicator sensor.
^
Secure the lead in the clips.
11. Bleed the brake system.
12. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs).
13. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.