Range Rover (LM) V8-4.4L (2009)
7. Remove the rear brake disc.
^
Remove the Allen screw.
Installation
1. Make sure that the rear brake disc and hub mating surfaces are clean.
CAUTION: Brake discs must be renewed in pairs.
2. Install the rear brake disc.
^
Tighten the Allen screw to 16 Nm (12 ft. lbs.).
3. Install the brake caliper.
^
Clean the component mating faces.
^
Tighten the new bolts to 15 Nm (11 ft. lbs.). plus a further 60 degrees.
4. Adjust the parking brake.
5. Install the rear wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
6. Connect the battery ground cable.