Range Rover (LM) V8-4.4L (2009)
Brake Rotor/Disc: Testing and Inspection
Brake Disc Runout Check, Rear
Rear Brake Disc Runout Check
Service Repair No - 70.12.36.01
Special Service Tools
NOTE: If the parking brake shoes or the brake discs have been removed for access to other components then DO NOT carry out the bedding in
procedure.
CAUTION: Do not turn the ignition on when the parking brake service mode has been set, this will result in the parking brake being released
from the service mode.
1. Enter the parking brake into the service mode.
^
Turn the ignition key to position II.
^
Apply, and hold, the footbrake.
^
Apply, and hold, the parking brake switch to the RELEASE position.
^
Turn the ignition key to position '0' and remove the key.
^
Release the footbrake.
^
Release the parking brake switch.
CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
2. RH side only: Disconnect the brake pad wear indicator sensor.
3. Remove the brake caliper lower bolt.
4. Remove the brake pads.
^
Rotate the brake caliper upwards.
^
Remove the two clips.
5. Remove the brake caliper upper bolt.