Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1442003.png)
11. Rotate the brake disc one revolution to measure the brake disc run-out.
^
Brake disc run-out must not exceed 0.09 mm.
12. If the brake disc run-out is outside the limit. Remove the brake disc.
13. Make sure the brake disc and hub mating surfaces are clean.
14. Install the brake disc.
^
Tighten the Torx(R) screw to 35 Nm (26 ft. lbs).
15. Install the wheel nuts.
^
Install spacer washers under the wheel nuts.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs).
16. Rotate the brake disc one revolution to measure the brake disc run-out.
^
Brake disc run-out must not exceed 0.09 mm.
17. If the brake disc run-out is still outside the limit, install a new brake disc and/or hub.
18. Remove the dial indicator gauge and the special tool.
19. Install the anchor plate.
^
Tighten the bolts to 115 Nm (85 ft. lbs).
20. Install the brake caliper housing and fit the top bolt.
^
Tighten the bolt to 32 Nm (24 ft. lbs).
21. Install the brake pads.
^
Install the 2 clips.
^
Install the two clips.
22. Rotate the brake caliper downwards.
^
Tighten the bolt to 32 Nm (24 ft. lbs).
23. Connect the brake pad wear indicator sensor.
24. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
