Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1447004.png)
5. Connect T4 to the vehicle, select diagnostic and proceed as directed for bleeding the brake system.
6. Starting at the brake caliper furthest away from the brake master cylinder, loosen the bleed screw by one-half to three quarters of a turn.
7. Install the bleed tube to the brake caliper bleed screw and immerse the free end of the bleed tube in a bleed jar containing a small quantity of
approved brake fluid.
CAUTION: The brake fluid reservoir must remain full with new, clean brake fluid at all times during bleeding.
8. With assistance, depress the brake pedal steadily through its full stroke and allow it to return to the rest position. Repeat the procedure until brake
fluid, clean and air-free flows into the bleed jar.
9. When brake fluid, clean and air-free flows into the bleed jar, depress and hold the brake pedal down.
CAUTION: Make sure the bleed screw cap is installed after bleeding. This will prevent corrosion to the bleed screw.
10. With the brake pedal fully depressed, tighten the bleed screw to 10 Nm (7 ft. lbs).
11. Fill the brake fluid reservoir to the MAX mark.
WARNING: Braking efficiency may be seriously impaired if an incorrect bleed sequence is used.
