Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1451012.png)
10. With the brake pedal fully depressed, tighten the bleed screw to 10 Nm (7 ft. lbs.).
11. Fill the brake fluid reservoir to the MAX mark.
WARNING: Braking efficiency may be seriously impaired if an incorrect bleed sequence is used.
12. Repeat the brake bleeding procedure for each brake caliper, following the above sequence.
13. Fill the brake fluid reservoir to the MAX mark.
14. Apply the brakes and check for leaks.
15. Install the brake fluid reservoir cap.
^
Connect the brake fluid reservoir electrical connector.
16. On completion, road test the vehicle and check the brake pedal operation. The pedal travel should be short with a firm feel.
Brake System Pressure Bleeding
Brake System Pressure Bleeding
Service Repair No - 70.25.02
WARNING: If any components upstream of the Hydraulic Control Unit (HCU), including the HCU itself are replaced, the brake system
must be bled using the procedure on T4, to ensure that all the air is expelled from the new component(s).
NOTE: The following procedure covers bleeding the complete system. Where only the primary or secondary brake circuits have been disturbed in
isolation, it should only be necessary to bleed that circuit. Partial bleeding of the hydraulic system is only permissible if a brake tube or hose has been
disconnected with only minimal loss of fluid.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Check that all the brake line connections are tight and that there are no signs of leaks.
3. Release the 3 clips and remove the cover.
WARNING: Do not allow dirt or foreign liquids to enter the reservoir. Use only new brake fluid of the correct specification from airtight
containers. Do not mix brands of brake fluid as they may not be compatible.
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
4. Fill the brake fluid reservoir to the MAX mark.
5. Install the bleed tube to the brake caliper bleed screw and immerse the free end of the bleed tube in a bleed jar containing a small quantity of
