Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1452002.png)
NOTE: Use an additional wrench to prevent the component from rotating.
7. Remove the brake caliper housing.
^
Remove the brake caliper upper bolt.
Installation
WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
1. Clean the caliper housing and anchor plate using brake cleaning fluid.
CAUTION: The brake caliper should move freely on both slide pins.
CAUTION: If necessary, renew the components.
2. Check the caliper slide pins.
^
Check for correct operation.
^
Check the condition of the caliper slide pin seals.
NOTE: Use an additional wrench to prevent the component from rotating.
3. Install the brake caliper.
^
Tighten the brake caliper upper bolt to 35 Nm (26 ft. lbs).
4. Install the brake pads.
^
Install the two clips.
NOTE: Use an additional wrench to prevent the component from rotating.
5. Secure the brake caliper.
^
Rotate the brake caliper downwards.
^
Tighten the brake caliper lower bolt to 35 Nm (26 ft. lbs).
6. Connect the brake hose to the brake caliper.
^
Clean the component mating faces.
^
Remove the blanking caps from the ports.
^
Install new sealing washers.
^
Tighten the brake hose union to 32 Nm (24 ft. lbs).
7. LH side only: Connect the brake pad wear indicator sensor.
^
Secure in the clip.
8. Bleed the brake system.
9. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs).
Brake Caliper - Vehicles With: High Performance Brakes
Brake Caliper - Vehicles With: High Performance Brakes
