Range Rover (LM) V8-4.4L (2009)
Installation
WARNING: Make sure that new nuts are installed.
1. Install the brake master cylinder.
^
Clean the component mating faces
^
Install a new seal
^
Tighten the nuts are 26 Nm (19 ft. lbs.)
NOTE: Remove and discard the blanking caps
2. Connect the brake pipes.
^
Tighten the nuts to 14 Nm (10 ft. lbs.)
3. Install the brake fluid reservoir.
Brake Fluid Reservoir - Vehicles With: Standard Brakes
Brake Fluid Reservoir - Vehicles With: Standard Brakes
Service Repair No - 70.25.31
Removal
CAUTION: If brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
1. Disconnect the low brake fluid warning indicator switch electrical connector.
^
Release the wiring harness