Range Rover V8-44L (2009) Brake Booster Repair – Standard Brakes (Page 4377)
8. Release the brake booster.
^
Remove and discard the 2 nuts.
^
Release the brake booster push rod from the brake pedal.
9. Remove the brake booster.
^
Remove and discard the gasket.
Installation
WARNING: Make sure that new nuts are installed.
CAUTION: The nuts must be re-torqued after 20 minutes.
NOTE: Install a new gasket.
1. Install the brake booster.
^
Tighten the nuts to 26 Nm (19 ft. lbs.).
^
Secure the brake booster push rod to the brake pedal.
2. Install the driver side closing trim panel.
^
Connect the footwell lamp electrical connector.
^
Secure the vehicle diagnostic socket.
^
Tighten the screws.
3. Install the floor console extension.
^
Secure the clips.
^
Tighten the screw.
4. Connect the brake booster vacuum hose to the brake booster.
5. Install the brake master cylinder.
6. Install the auxiliary battery compartment side wall.
^
Install the 2 nuts.
^
Install the 3 bolts.
^
Install the wiper motor support bracket bolt.
^
Connect the hood switch electrical connector.
7. Install the plenum chamber.
8. Connect the battery ground cable.