Range Rover (LM) V8-4.4L (2009)
Yaw Rate Sensor: Service and Repair
Yaw Rate Sensor
Service Repair No - 70.70.35
Removal
1. Disconnect the battery ground cable.
2. Remove the auxiliary heater core and evaporator core housing.
3. Remove the yaw rate sensor.
^
Disconnect the electrical connector.
^
Remove the 2 bolts.
Installation
1. Install the yaw rate sensor.
^
Install the 2 bolts and tighten to 7 Nm (5 ft. lbs.).
^
Connect the electrical connector.
2. Install the auxiliary heater core and evaporator core housing.
3. Connect the battery ground cable.