Range Rover (LM) V8-4.4L (2009)
Thermostat: Service and Repair
Thermostat
Service Repair No - 26.45.01
Removal
1. Disconnect the battery ground cable.
2. Remove the air intake resonator.
3. Remove the thermostat housing.
^
Position a container to collect the fluid.
^
Release the clip.
^
Disconnect the coolant hose.
^
Remove the 3 bolts.
^
Remove and discard the seal.
4. Remove the thermostat.
WARNING: Eye protection must be worn.
NOTE: Do not disassemble further if the component is removed for access only.
^
Position the thermostat housing in a vice.
^
Release and remove the thermostat.
Installation
1. Install the thermostat.
^
Clean the component mating faces.
^
Install the components.
2. Install the thermostat housing.
^
Clean the component mating faces.
^
Install a new thermostat seal.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
^
Connect the hose and secure with the clip.