Range Rover (LM) V8-4.4L (2009)
10. Remove the special tool.
CAUTION: Make sure that the crankshaft rear oil seal is correctly located.
NOTE: Prevent the flexplate from rotating.
11. Install the torque converter flexplate.
^
Clean the component mating faces.
^
Tighten the bolts evenly in 2 stages to the sequence shown.
^
Tighten the bolts to 15 Nm (11 ft. lbs.).
^
Tighten the bolts to 110 Nm (81 ft. lbs.).
12. Install the special tool.
13. Connect the battery positive cable and the switch lead to the starter motor solenoid.
^
Connect the battery positive cable.
^
Connect the electrical connector.
^
Install the battery positive cable cover.
14. Install the starter motor.
^
Clean the component mating faces.
^
Tighten the bolt to 45 Nm (33 ft. lbs.).
15. Install the oil pump.
16. Connect the battery ground cable.