Range Rover (LM) V8-4.4L (2009)
19. LH side: Release the engine mount.
^
Remove the bolt.
20. LH side: Remove the engine mount.
^
Using a transmission jack, raise the engine clear of the engine mount.
^
Remove the 2 bolts.
Installation
All vehicles
1. LH side: Install the engine mount.
^
Tighten the engine mount to subframe bolts to 56 Nm (41 ft. lbs.).
2. LH side: Install the engine mount heat shield.
^
Tighten the screws.
3. Lower the engine onto its mounts.
^
Tighten the bolt to 100 Nm (74 ft. lbs.).
^
Tighten the nut to 100 Nm (74 ft. lbs.).
4. LH side: Install the engine compartment heat shield.
^
Tighten the screws.
^
Tighten the nuts.