Range Rover (LM) V8-4.4L (2009)
Air Door Actuator / Motor: Service and Repair
Auxiliary Footwell Vent/Duct Blend Door Actuator
Auxiliary Footwell Vent/Duct Blend Door Actuator
Removal
1. Disconnect the battery ground cable.
2. Remove the floor console rear trim panel.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.
3. Remove the footwell vent/duct blend door actuator link rod.
-
Disconnect the electrical connector.
4. Remove the footwell vent/duct blend door actuator.
-
Remove the 2 screws.
Installation
1. Install the footwell vent/duct blend door actuator.
-
Install the 2 screws.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.
2. Install the footwell vent/duct blend door actuator link rod.
-
Connect the electrical connector.
3. Install the floor console rear trim panel.
4. Connect the battery ground cable.