Range Rover (LM) V8-4.4L (2009)
36. Remove the 3 nuts securing the wiring harness carrier to the in-vehicle crossbeam.
^
Release the wiring harness carrier from the in-vehicle crossbeam.
37. Remove the heater and evaporator core housing to floor ducts.
^
Position the heater and evaporator core housing assembly in an upwards direction.
38. With assistance, remove the in-vehicle crossbeam.
^
Release the wiring harness rearwards for in-vehicle crossbeam removal access.
Installation
1. With assistance, install the in-vehicle crossbeam.
2. Install the heater and evaporator core housing to floor ducts.
3. Locate the wiring harness carrier to the in-vehicle crossbeam and install the nuts.
4. Install the in-vehicle crossbeam to the bulkhead.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
5. Secure the heater and evaporator core housing to the in-vehicle crossbeam.
6. Secure the wiring harness to the in-vehicle crossbeam.
^
Secure with a tie-strap.
7. Install the CJB.
^
Secure the wiring harness clip.
^
Install the screws.
^
Install the 2 relays to the passenger side of the in-vehicle crossbeam.
8. Install the audio unit.
^
Connect the electrical connectors.
9. Secure the audio unit.
^
Install the screws.
^
Secure the wiring harness clip.
10. Connect the electrical connectors to the air suspension control module.
^
Secure the wiring harness clip.
11. Secure the battery positive cables.
^
Secure with a tie-strap.
12. Install the passenger side footwell duct.
^
Install the screw.
13. Secure the wiring harness to the passenger side of the in-vehicle crossbeam.
^
Secure the wiring harness clips.