Range Rover (LM) V8-4.4L (2009)
Brake Lamp: Service and Repair
Rear Lamp Assembly
Removal
CAUTION: Always protect paintwork and glass when removing exterior components.
1. Remove the rear lamp assembly.
-
Remove the 2 screws.
-
Disconnect the electrical connector.
NOTE: Do not disassemble further if the component is removed for access only.
2. Remove the bulb holder.
-
Release the 2 clips.
-
Disconnect the 2 electrical connectors.
3. Remove the 3 bulbs.
Installation
1. Install the bulbs.
2. Install the bulb holder.
-
Connect the electrical connectors.
3. Install the rear lamp assembly.
-
Connect the electrical connector.
-
Tighten the screws.