Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2521001.png)
Brake Light Switch: Service and Repair
Stoplamp Switch
Removal
CAUTION: The brake pedal MUST NOT be depressed during this operation. Failure to comply will result in damage to the stoplamp
switch.
1. Remove the closing trim panel.
-
Release the clip.
-
Remove the 2 screws.
-
Disconnect the electrical connector.
2. Remove the stoplamp switch.
-
Disconnect the electrical connector.
-
Rotate the switch clockwise.
Installation
CAUTION: The brake pedal MUST NOT be depressed during this operation. Failure to comply will result in damage to the stoplamp
switch.
1. Install the stoplamp switch.
-
Rotate the switch counterclockwise.
-
Connect the electrical connector.
2. Install the closing trim panel.
-
Connect the electrical connector.
-
Secure the clip.
-
Tighten the screws.
