Range Rover (LM) V8-4.4L (2009)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor
Removal
1. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the engine undershield.
CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any
open connections to prevent contamination.
4. Remove the CKP sensor.
^
Disconnect the electrical connector.
^
Remove the Torx screw.
Installation
1. Install the CKP sensor.
^
Tighten the Torx screw to 8 Nm (6 ft. lbs.).
^
Connect the CKP sensor electrical connector.
2. Install the engine undershield.
3. Connect the battery ground cable.