Range Rover (LM) V8-4.4L (2009)
Knock Sensor: Service and Repair
Knock Sensor (KS)
Removal
NOTE: The knock sensors are supplied as a pair.
1. Disconnect the battery ground cable.
2. Remove the intake manifold assembly.
3. Remove the knock sensors (KS).
^
Disconnect the electrical connector.
^
Remove the 2 bolts.
Installation
1. Install the KS.
^
Clean the component mating faces.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
^
Install the NVH pad.
^
Connect the electrical connector.
2. Install the intake manifold assembly.
3. Connect the battery ground cable.