Range Rover (LM) V8-4.4L (2009)
Canister Purge Control Valve: Service and Repair
Evaporative Emission Canister Purge Valve
Removal
1. Disconnect the battery ground cable.
2. Remove the engine cover.
CAUTION:
^
Damage will occur to the purge valve line assembly, if it is distorted in any way.
^
Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open
connections to prevent contamination.
3. Remove the purge valve assembly.
^
Disconnect the line at both ends.
^
Disconnect the purge valve electrical connector.
^
Remove the bolt. Release the clip.
Installation
1. Install the purge valve assembly.
^
Clean the component mating faces.
^
Connect the PCV line.
^
Tighten the purge valve bolt to 6 Nm (4 ft. lbs.).
^
Secure the line clip.
^
Connect the PCV electrical connector.
2. Install the engine cover.
3. Connect the battery ground cable.