Range Rover (LM) V8-4.4L (2009)
Evaporative Emission Control Canister: Service and Repair
Evaporative Emission Canister
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Disconnect the battery ground cable.
3. Remove the rear driveshaft.
4. Remove the RH fuel tank shield.
^
Remove the 8 bolts.
^
Remove the 2 nuts.
5. Remove the evaporative emissions canister.
^
Remove the 2 bolts.
^
Disconnect the 3 lines.
Installation
1. Install the evaporative emissions canister.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
^
Connect the lines.
2. Install the RH fuel tank shield.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
3. Install the rear driveshaft.
4. Connect the battery ground cable.