Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1182001.png)
Clutch Pressure Regulating Solenoid: Service and Repair
Transfer Case Clutch Solenoid
Service Repair No - 41.30.08
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
CAUTION: Connect T4, prior to removal of the solenoid.
NOTE:
Some fluid spillage is inevitable during this operation.
2. Remove the transfer case clutch solenoid.
^
Position a container to collect the fluid spillage.
^
Remove the 3 Torx screws.
^
Use T4 to energize the solenoid.
^
Detach from the selector lever.
^
Disconnect the electrical connector.
Installation
CAUTION: Make sure the seal is installed correctly.
1. Install the transfer case clutch solenoid.
^
Clean the components.
^
Connect the electrical connector.
^
Use T4 to energize the solenoid.
^
Install to the selector lever.
^
Tighten the Torx screws to 6 Nm (4 ft. lbs.).
2. Check and top-up the transfer case fluid level.
3. Using T4, calibrate a new transfer case control solenoid.
