Range Rover (LM) V8-4.4L (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module - Vehicles With: Standard Brakes
Anti-Lock Brake System (ABS) Module - Vehicles With: Standard Brakes
Service Repair No - 70.25.12
Removal
CAUTION: Make sure the ignition switch is in position 0.
NOTE: The hydraulic control unit (HCU) mounted to the ABS module cannot be serviced separately. If the HCU requires replacement, then the ABS
module must be replaced as a complete assembly.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Disconnect the battery ground cable.
3. Disconnect the electrical connector.
^
Release the latch.
^
Reposition the electrical connector.
CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug
open connections to prevent contamination.
NOTE: Note the fitted position.
4. Release the 6 brake fluid lines.
^
Position an absorbent cloth to collect fluid spillage.
5. Remove the ABS module.
^
Loosen but do not remove the 2 nuts.
^
Release from the locating grommet.