Range Rover (LM) V8-4.4L (2009)
^
Remove the 4 screws.
^
Disconnect the 5 electrical connectors from the speed control switch and steering wheel audio controls.
Installation
1. Install the speed control switch and steering wheel audio controls
^
Connect the 5 electrical connectors to the speed control switch and steering wheel audio controls.
^
Install the 4 screws and tighten to 3 Nm (2 ft. lbs.).
2. NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
Position the driver air bag module and connect the 3 electrical connectors.
3. Locate the driver air bag module and carefully push to secure the clips.
4. Connect the battery ground cable.