Range Rover (LM) V8-4.4L (2009)
4. Remove the driver air bag module.
^
Disconnect the 3 electrical connectors.
5. NOTE: Do not disassemble further if the component is removed for access only.
Remove the speed control switch and steering wheel audio controls.
^
Remove the 4 screws.
^
Disconnect the 5 electrical connectors from the speed control switch and steering wheel audio controls.
Installation
1. Install the speed control switch and steering wheel audio controls
^
Connect the 5 electrical connectors to the speed control switch and steering wheel audio controls.
^
Install the 4 screws and tighten to 3 Nm (2 ft. lbs.).
2. NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
Position the driver air bag module and connect the 3 electrical connectors.
3. Locate the driver air bag module and carefully push to secure the clips.
4. Connect the battery ground cable.
Front Seat Side Air Bag Module
Front Seat Side Air Bag Module