Range Rover (LM) V8-4.4L (2009)
8. Remove the front safety belt buckle.
^
Remove and discard the bolt.
Installation
1. Install the front safety belt buckle.
^
Install a new bolt and tighten to 40 Nm (30 ft. lbs.).
2. Connect the front safety belt buckle electrical connector.
^
Secure the wiring harness clip.
3. WARNING: Make sure the front safety belt buckle wiring harness is correctly routed and secured in the position shown. Failure to
follow this instruction may result in personal injury.
CAUTION: Make sure the front safety belt buckle wiring harness is correctly routed and secured in the position shown. Failure to follow
this instruction may result in damage to the vehicle.
Reposition the front safety belt buckle wiring harness.
4. Install the front seat backrest hinge cover.
^
Secure the clip.
^
Install the 2 screws.
5. Install the front seat side trim panel support.
^
Secure the 2 clips.
6. Secure the 2 lower tension straps to the front seat base.
^
Reposition the front seat backrest cover.
7. Install the front seat.
8. Connect the battery ground cable.