Range Rover (LM) V8-4.4L (2009)
Oil Temperature Sensor/Switch: Service and Repair
Oil Temperature Sensor
Service Repair No - 12.60.65
Removal
1. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the radiator splash shield.
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open
connections to prevent contamination.
4. Remove the oil temperature sensor.
^
Disconnect the electrical connector.
^
Position a container to collect the fluid.
Installation
1. Install the oil temperature sensor.
^
Clean the component mating faces.
^
Tighten the oil temperature sensor to 10 Nm (7 ft. lbs.).
^
Connect the electrical connector.
2. Install the radiator splash shield.
3. Connect the battery ground cable.
4. Check and top-up the engine oil.