Range Rover (LM) V8-4.4L (2009)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Removal
1. Disconnect the battery ground cable.
2. Remove the engine cover.
NOTE: LH bank sensor only.
3. Release the engine wiring harness clips.
^
Remove the 2 bolts.
^
Position the wiring harness aside for access.
4. Disconnect the camshaft position (CMP) sensor electrical connector.
^
Slide the red connector latch to one side.
^
Depress the concealed clip.
NOTE: Removal of the RH is similar to this procedure.
5. Remove the CMP sensor.
^
Remove the bolt.
^
Discard the O-ring seal.
Installation
1. Install the CMP sensor.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Tighten the bolt to 7 Nm (5 ft. lbs.)
2. Connect the CMP sensor electrical connector.
^
Secure the red latch.
NOTE: LH bank sensor only.
3. Secure the engine wiring harness clips.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
4. Install the engine cover.
5. Connect the battery ground cable.