Range Rover (LM) V8-4.4L (2009)
Gear Sensor/Switch: Service and Repair
High/Low Range Sensor
Service Repair No - 41.30.07
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the transmission support insulator nut, bolt and damper.
^
Support the transmission.
CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.
3. Remove the high/low range sensor.
^
Lower the transmission.
^
Disconnect the electrical connector.
^
Remove the 2 Torx bolts.
Installation
1. Install the high/low range sensor.
^
Clean the components.
^
Tighten the Torx bolts to 6 Nm (4 ft. lbs.).
^
Connect the electrical connector.
2. Install the transmission support insulator nut, bolt and damper.
^
Tighten the bolt to 115 Nm (85 ft. lbs.).
3. Using T4, calibrate a new high/low range sensor.