Range Rover (LM) V8-4.4L (2009)
Installation
1. Install the starter motor.
^
Clean the component mating faces.
^
Connect the electrical connectors.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
^
Install the terminal nut insulator.
^
Install the terminal cover.
^
Tighten the bolts to 45 Nm (33 ft. lbs.).
2. Install the starter motor heat shield.
^
Tighten the bolts to 45 Nm (33 ft. lbs.).
3. Install the engine compartment RH heat shield.
^
Tighten the screws.
^
Tighten the nuts.
4. Install the front wheel.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
5. Install the engine undershield.
6. Connect the battery ground cable.