Range Rover (LM) V8-4.4L (2009)
Power Steering Bleeding: Service and Repair
Power Steering System Filling and Bleeding
1. Check the power steering fluid level.
CAUTION: Fluid must always be present in the reservoir during bleeding.
2. Remove the filler cap and fill to the UPPER level mark.
^
Install the reservoir filler cap.
3. Start the engine and allow to run for 10 seconds, stop the engine.
^
Check the power steering fluid, if aerated, wait until fluid is free from bubbles then top-up reservoir to UPPER level mark with recommended
fluid.
CAUTION: Do not hold steering on full lock for longer than 10 seconds.
4. Start the engine and turn steering fully lock to lock, stop the engine.
^
Check and top-up power steering fluid level.
5. Start and run the engine for 2 minutes, turn the steering fully lock to lock.
^
Check and top-up power steering fluid level.