Range Rover (LM) V8-4.4L (2009)
WARNING: Make sure that a new bolt is installed.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
2. Secure the LH front lower arm.
^
Tighten the nut and bolt to 165 Nm (121 ft. lbs.). plus a further 90 degrees.
3. LH front: Secure the suspension height sensor link.
4. Repeat the above procedure for the RH side.
5. Install the wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
6. Check, and if necessary, adjust the wheel alignment.
Rear Lower Arm Bushing
Rear Lower Arm Bushing
Service Repair No - 60.35.26
Special Service Tools
Removal
1. Remove the LH rear lower arm.
2. Using the special tools, remove the rear lower arm bushes.
Installation
1. Using the special tools, install the rear lower arm bushes.