Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1693004.png)
1. Install the wheel knuckle assembly.
^
Tighten the nuts and bolts to 250 Nm (184 ft. lbs.).
2. Locate the halfshaft in the wheel hub.
^
Lightly lubricate the halfshaft splines.
^
Clean the halfshaft and wheel hub splines.
3. Using the special tool, pull the halfshaft in to the wheel hub.
4. Remove the special tool.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
5. Secure the RH rear lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the rear lower arm nut and bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
6. Secure the RH front lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the lower arm nuts and bolts to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
7. RH side front: Secure the suspension height sensor.
8. Secure the RH tie rod end.
^
Install a new nut and tighten to 80 Nm (59 ft. lbs.).
9. Secure the RH front ABS sensor and wiring harness.
^
Apply anti-seize compound to the ABS sensor.
^
Tighten the bolt to 8 Nm (6 ft. lbs.)
^
Secure in the clip.
10. Install the RH front brake disc.
11. With assistance tighten the wheel hub nut to 420 Nm (311 ft. lbs.).
^
Use a new nut.
^
Stake the nut to the halfshaft.
12. Install the front wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
13. Check, and if necessary, adjust the wheel alignment.
