Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1694005.png)
Installation
CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
1. Install the wheel knuckle.
^
Clean the component mating faces.
^
Lightly lubricate the halfshaft splines.
^
Connect to the tie rod.
^
Install the special bolt to the upper arm.
2. Secure the upper arm and wheel knuckle.
^
Align the bolt to the marks made previously.
^
Install the special washer.
^
Install a new nut and lightly tighten.
3. Using the special tools, install the halfshaft in the wheel hub.
CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
4. Secure the lower arm and wheel knuckle.
^
Install a new nut and bolt and tighten to 250 Nm (184 ft. lbs.).
CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
NOTE:
Use an additional wrench to prevent the component from rotating.
5. Install the toe link nut and tighten it to 165 Nm (121 ft. lbs.).
6. Install a new halfshaft retaining nut and lightly tighten.
7. Install the parking brake cable.
^
Clean the component mating faces.
^
Tighten the bolt to 8 Nm (6 ft. lbs.)
8. Secure the parking brake cable clip.
^
Tighten the Allen screw to 5 Nm (4 ft. lbs.)
9. Install the rear wheel speed sensor.
^
Clean the component mating faces.
^
Tighten the Allen screw to 8 Nm (4 ft. lbs.)
^
Secure the lead in the clip.
