Range Rover (LM) V8-4.4L (2009)
Rear Knuckle Alignment Link: Service and Repair
Toe Link
Service Repair No - 64.35.70
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the wheel and tire.
3. Release the toe link from the wheel knuckle.
^
Remove the nut.
4. Release the height sensor link.
^
Remove the nut.
5. Mark the position of the bolt.
6. Remove the toe link.
^
Remove and discard the bolt.
^
Collect the washer.
Installation
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
1. Install the toe link.
^
Install a new bolt.
^
Align the bolt to the marks made previously.
^
Install the washer.
^
Tighten the nut and bolt to 165 Nm (121 ft. lbs.).
2. Secure the toe link to the wheel knuckle.
^
Tighten the nut to 165 Nm (121 ft. lbs.).