Range Rover (LM) V8-4.4L (2009)
^
Remove and discard the Voss connector and collet.
NOTE:
Do not disassemble further if the component is removed for access only.
7. Remove the support bracket.
^
Remove the Torx bolt.
Installation
1. Install the support bracket.
^
Tighten the Torx bolt to 25 Nm (18 ft. lbs.).
CAUTION: Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
NOTE:
New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new voss connectors if a
new component is being installed.
2. Install a new Voss connector to the air reservoir.
^
Tighten the new Voss connector to 5 Nm (4 ft. lbs.).
3. Install the air suspension reservoir.
^
Position a transmission jack to support the component.
^
Remove the Voss collet alignment peg.
^
Connect the air line.
^
Tighten the M6 bolts to 10 Nm (7 ft. lbs.).
^
Tighten the Torx bolt to 25 Nm (18 ft. lbs.).
4. Install the closing panel.
^
Install the nuts.
5. Connect the battery ground cable.