landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Relays and Modules - Wheels and Tires > < Vehicle Lifting|Lifting|Page 5484
Page 2
background image

-

Ensure that during towing, the towing attachment does not contact the bumper.

-

The rear towing/lashing eye should only be used for towing another vehicle or for recovery purposes to enable this vehicle to be positioned in
order that the front towing eye may be used for recovery/towing.

4 Wheel Towing

CAUTION:
-

Suspended towing of this vehicle MUST NOT be attempted, if four wheel towing is not possible, vehicle must be recovered on a suitable
trailer.

-

The vehicle may be towed for a maximum of 1 hour or 31 miles (50 km) at a maximum speed of 31 mph (50 km/h), these limits MUST
NOT be exceeded.

-

The following procedures must be followed to ensure that the vehicle is towed in a safe condition and damage to the vehicle transmission
system is prevented.

1. Remove the front towing/lashing eye access panel.
2. Secure the towing attachment from the recovery vehicle to the towing/lashing eye.

CAUTION:  Ensure that the towing attachment will not contact the front bumper during towing.

3. Apply the parking brake.
4. Insert ignition key and turn the ignition switch to position 'II'.

CAUTION:  If 'N' - Neutral cannot be selected, front and rear driveshafts must be removed before vehicle is towed.

5. Apply the footbrake and move the automatic transmission selector lever to the 'N' Neutral position.

NOTE:  If electrical power is not available, use the manual interlock release tab on the selector lever to move the selector lever to the
Neutral position.

6. Select 'H' - HIGH on the transfer box.

CAUTION:  If electrical power is not available, and 'H' - HIGH cannot be selected, the vehicle may not be towed but must be recovered
on a suitable trailer. If, however, the transfer box was in 'H' - HIGH when electrical power was lost, the vehicle may still be towed.

7. Release the parking brake.

WARNING:  Do not release the parking brake until towing is about to commence. Whilst towing, do not attempt to remove the ignition
key and do not turn the key to any position other than 'II'. With the engine switched off, the power assisted steering system and brake
booster will be inoperative thereby resulting in an increase in the effort required to turn the steering wheel and apply the brakes.

CAUTION:  The vehicle tow connections should only be used in normal road conditions, 'snatch' recovery must be avoided.

On completion of 4 wheel towing

1. Apply the parking brake.
2. Detach towing equipment from towing/lashing eyes.
3. Install the towing eye access panel.

Transporting by trailer

CAUTION:  Use the towing/lashing eyes at the front and rear of the vehicle, DO NOT secure lashing hooks or restraints to any other part of
the vehicle.

Position the vehicle, apply the parking brake and select 'N' - Neutral on the automatic transmission selector lever.

Relays and Modules - Wheels and Tires > < Vehicle Lifting|Lifting|Page 5484