Range Rover (LM) V8-4.4L (2009)
Removal
CAUTION: Do not allow halfshafts to hang unsupported at one end or joint damage will occur.
CAUTION: Do not store or install halfshafts with joints at maximum articulation or damage may occur to the joint.
CAUTION: Angularly Adjusted Roller (AAR) joints, used at the inboard end of some halfshafts have no internal retaining mechanism and
can separate.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the rear wheel and tire.
NOTE:
Use an additional wrench to prevent the component from rotating.
3
Release the tie rod.
^
Remove and discard the nut.
4. Release the lower arm.
^
Using a suitable stand, support the lower arm.
^
Remove and discard the nut and bolt.