Range Rover (LM) V8-4.4L (2009)
CAUTION: Pull on the halfshaft inboard joint to make sure the clip has fully engaged and retains the halfshaft inboard joint within the
axle case.
2. With assistance, secure the halfshaft.
^
Clean the component mating faces.
^
Install a new snap ring.
^
Open the axle shaft seal protector.
NOTE:
LH illustration shown, RH is similar.
NOTE:
The axle shaft seal protector is designed to break into two pieces.
3. Remove and discard the axle shaft seal protector.
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
4. Secure the lower arm.
^
Install a new nut and bolt and tighten to 250 Nm (184 ft. lbs.).
NOTE:
Use an additional wrench to prevent the component from rotating.
5. Secure the tie rod.
^
Install a new nut and tighten to 165 Nm (121 ft. lbs.).
6. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
Drive Pinion Seal
Drive Pinion Seal
Service Repair No - 51.20.01
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.