Range Rover (LM) V8-4.4L (2009)
Drive/Propeller Shaft: Service and Repair
Front Driveshaft
Front Driveshaft - 4.2L/4.4L
Service Repair No - 47.15.02
Removal
CAUTION: It is possible to fit the driveshaft incorrectly. Note the orientation before removal.
NOTE:
A small amount of oil may weep from the driveshaft joints during storage. The loss of this oil will not affect the operation or durability of the joint.
1. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the transmission support crossmember.
CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
4. Release the driveshaft from the transfer case drive flange.
^
Remove the 6 Torx bolts and washers, discard the bolts.
CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
5. Release the driveshaft from the front axle drive flange.
^
Remove the 6 Torx bolts and washers, discard the bolts.
6. Remove the front driveshaft.
^
Compress the joints to disengage the drive flanges.