Range Rover (LM) V8-4.4L (2009)
7. Loosen the RH tie rod end locking nut.
CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
8. Using the special tool release the RH tie rod end.
^
Remove and discard the nut.
9. RH side front: Release the suspension height sensor.
10. Using the special tool release the RH front lower arm.
^
Remove the nut.
^
Loosen the nut and bolt.
11. Using the special tool release the RH rear lower arm.
^
Loosen the nut and bolt.
^
Remove the nut.