Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1348005.png)
4. Using the special tool, install a new oil seal.
^
Clean the component mating faces.
^
Grease the new seal.
CAUTION: Centralize the snap ring in the snap ring groove before installing the output flange.
CAUTION: Extreme care is necessary to make sure the snap ring enters the bearing squarely.
5. Using the special tool and with assistance, install the drive flange.
^
Clean the component mating faces.
^
Install a new snap ring.
^
Make sure the snap ring is fully engaged and retains the drive flange.
CAUTION: Make sure the washers are installed correctly.
6. Install the 2 special washers.
^
Clean the components.
CAUTION: Make sure the oil pump is installed over its location peg.
7. Install the input shaft and oil pump assembly.
^
Clean the components.
^
Secure the fluid pickup line.
