Range Rover (LM) V8-4.4L (2009)
Transfer Case Actuator: Service and Repair
Transfer Case Shift Motor
Service Repair No - 41.30.03
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the transmission support insulator nut, bolt and damper.
^
Support the transmission.
CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.
3. Remove the shift motor.
^
Lower the transmission.
^
Disconnect the electrical connector.
^
Remove the 4 Torx bolts.
Installation
1. Install the shift motor.
^
Clean the components.
^
Tighten the Torx bolts to 25 Nm (18 ft. lbs.).
^
Connect the electrical connector.
2. Install the transmission support insulator nut, bolt and damper.
^
Raise the transmission.
^
Tighten the nut and bolt to 115 Nm (85 ft. lbs.).
3. Use T4 to re-calibrate a new transfer case shift motor.