Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2661002.png)
Installation
1. Install the finisher trim to the liftgate window glass.
2. Install the liftgate window glass support blocks to the liftgate.
3. With assistance, install the liftgate window glass and centralize in the liftgate aperture.
^
Use masking tape to establish reference marks and to aid as an alignment guide.
^
Attach suction cups to aid alignment and install.
4. With assistance, remove the liftgate window glass and place on the felt covered supports.
5. Using the recommended solvent, clean the sealant mating faces of the liftgate and the liftgate window glass.
6. Apply etch primer to any liftgate bare metal.
7. Apply primer over the previously applied etch primer.
8. Apply glass primer to the sealant mating face of the liftgate window glass and allow to cure.
9. Apply activator over the old sealant on the liftgate and allow to cure.
10. Install the pre-cut nozzle to sealant cartridge and remove the lid and shake out the crystals, followed by installing the cartridge to the applicator
tool.
^
If necessary, modify the nozzle to achieve the required bead section.
11. Apply a continuous bead of sealant to the liftgate window glass as shown.
12. With assistance, install and align the liftgate window glass.
^
Lightly press the liftgate window glass to seat the sealant.
13. Remove the masking tape and exterior paintwork protection.
14. Connect the liftgate window glass electrical connectors.
15. Test the liftgate window glass sealant for leaks.
^
If water is used as a means for the leak check, then allow sealant to dry before testing.
^
Spray water around the liftgate window glass, mark any area that leaks. Dry the liftgate window glass and sealant before applying additional
sealant.
16. Install the liftgate LH and RH inner side trim panels.
17. Install the liftgate lower trim panel.
18. Install the rear window wiper pivot arm.
