Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2715001.png)
Windshield Washer Reservoir: Service and Repair
Windshield Washer Reservoir
Service Repair No - 84.10.03
Removal
1. Remove the front LH fender splash shield.
2. Release the filler neck from the windshield washer reservoir.
^
Position a container to collect any windshield washer reservoir spillage.
^
Remove and discard the seal.
3. NOTE: Note the position of the electrical connectors.
Disconnect the 3 electrical connectors from the windshield washer reservoir pumps.
4. NOTE: Note the position of the hoses.
Disconnect the 3 hoses from the windshield washer reservoir pumps.
5. Disconnect the low washer fluid warning indicator switch electrical connector.
6. Disconnect the windshield washer reservoir vent pipe.
7. Remove the windshield washer reservoir.
1. Remove the 2 bolts.
2. Release the windshield washer reservoir from the front mounting.
8. NOTE: Do not disassemble further if the component is removed for access only.
Remove the 3 windshield washer reservoir pumps and discard the 3 seals.
Installation
1. Install the windshield washer reservoir pumps.
^
Clean the component mating faces.
^
Install new seals.
2. Install the windshield washer reservoir.
^
Tighten the bolts to 3 Nm (2.2 ft. lbs.).
3. Connect the windshield washer reservoir vent pipe.
4. Connect the low washer fluid warning indicator switch electrical connector.
5. Connect the windshield washer reservoir electrical connectors.
6. Connect the windshield washer reservoir pump hoses.
7. Install the windshield washer reservoir filler neck.
^
Clean the component mating faces.
^
Install a new seal to the windshield washer filler neck.
8. Fill the windshield washer reservoir with the correct fluid and concentration.
9. Install the front LH fender splash shield.
